Professional Exclusive Crest Whitening Emulsions with LED Light

Crest Whitening Emulsions is uniquely formulated with highly active microdroplets that whiten while keeping teeth hydrated, so there’s virtually no sensitivity.

*vs ARC pen whitening

Returns for all Crest Whitening Emulsions are not accepted due to temperature control requirements.

Innovative emulsion technology whitens while keeping teeth hydrated.

Highly active microdroplets diffuse to stains on contact. LED Blue Light dramatically boosts results by weakening stains.

Applies in seconds. No need to rinse or remove.

Enhance your whitening results with the LED Accelerator Light.

Applying our LED Blue Light after 30 minutes of having used Crest Emulsions will accelerate stain break-down to get 50% Faster results vs using emulsions alone.

1. SQUEEZE: Give your tube a good squeeze so the teeth whitening emulsion dispenses onto the wand applicator, covering the entire tip.
2. APPLY IN SECONDS: Apply the product directly and liberally, making sure to cover all surfaces of your teeth. Feel free to use as many coats as needed to fully cover all the teeth you wish to whiten! Allow the emulsion to whiten for 30 minutes before applying the light. For best results, we recommend you do not eat or drink during this time.
3. BOOST: Enhance the whitening effects of Crest Whitening Emulsions with the LED Accelerator Light. To start the light, press the two buttons on the side of the light simultaneously, then release. Finally, hold the light against your teeth until the light turns off.
4. SMILE AND GO: Now, you’re ready to reveal your whiter smile.

1. Incorporate it into your daily beauty and grooming routine. The best part is there is virtually no sensitivity.
2. It is enamel-safe for use up to 4x per day for even better whitening results.
3. For noticeably whiter teeth, continue to apply for 14 treatments (Quick tip: You can get there in as little as four days if you follow recommendation No. 2.).
4. Don’t be fooled by the barely there feel. Rest assured it’s continuing to whiten your teeth long after you apply.
5. If you experience wetness in your mouth, this is quite normal. To make it easier to apply, you can dry your teeth with a paper towel before application.
6. Use as many coats as you need to fully cover all of the teeth you wish to whiten.
7. Before putting away your whitening wand and LED light, gently clean the wand applicator tip and light mouthpiece with soap and warm water, a tissue, paper towel or wipe, so it's ready to use the next time you whiten your teeth. The light is designed to be water-resistant for cleaning in the sink.